This means it can withstand weathering much better than other types of lumber, including cedar and pine. Pressure-treated wood is ideal for outdoor projects due to its resistance to rot and insect damage. Whether you are building a new deck, replacing rotting fence posts, or creating garden borders and accents, there are many times when a quick cut may be necessary. If you’re considering building a DIY project out of pressure-treated wood, then you should learn the proper way to cut it. The ground does not have to be exactly level according to a level it must be flat and level with the surrounding area.Do you need to know how to cut pressure treated wood? Properly cutting pressure-treated wood is essential for any home repair or renovation project involving this type of material. Make sure the soil is firmly packed to prevent settling.Ĭheck for level as you go, using a carpenter’s level or a straight board. Add soil, as needed, to bring the area up to the proper level, then pack it down again. Walk over the loosened soil to pack it down. Use a shovel, a steel rake, or a garden hoe to dig out rocks, roots, and other obstructions along the edging’s path. Prepare the ground at the edge of the border planting so that it is ready to receive the landscape timber edging. To make a 90-degree turn, you can simply butt the square ends of timbers together, but any other angle requires a miter cut this is easy once you know how to do it.ĭon’t Miss: How Much Do Landscapers Charge To Cut Grass Level And Tamp The Ground To turn corners with wood edging, you must fit the timbers together at an angle, much like with baseboard trim inside your house. To use landscape timbers on sloped ground, you’ll need to terrace the hill with trenches that will accommodate and stabilize the boards. Wood doesn’t easily bend or dip to conform to sloped ground or contours. The trick to installing timber edging is getting the ground flat and the edging path straight. Compared to stone or concrete edging blocks, timbers are less expensive and much quicker to install. It’s much more substantial and attractive than galvanized metal edging, and it will hold up better than plastic. You can also use landscape timber edging for lining areas of grass. They are different than railroad ties, which are thicker, heavier, and typically not pressure-treated, although some people opt to use them in landscapes. They are 3- to 8-inches wide and have edges designed for landscaping purposes. Landscape timbers are long pieces of solid pressure-treated wood. You can secure the pieces together with screws driven at an angle through both pieces, or you can bend a 90-degree corner brace to match the custom angle, and install the brace with screws. When you fit the angled ends together, they will make a 120-degree turn. Repeat the same process to mark and cut the mating timber so that each is cut at 60 degrees. Finally, draw a straight line through the 60-degree mark and the center mark to create an angled cutting line. Determine the desired angle for the completed turn, divide that angle in half, then mark the timber along the top of the protractor at the resulting angle.įor example, if the edging will turn at 120 degrees, mark the top of the timber at the 60-degree line on the protractor. Mark the edge of the timber at the protractor’s center mark. Place the protractor on top of the timber and align the protractor’s baseline with the edge of the timber. Use a protractor to lay out angle cuts for turns in your edging that are not 90 degrees. However, some landscape timbers have been known to last well over two decades. Pressure-treated landscape timbers can last for 15 to 20 years as opposed to untreated lumber which begins rotting in just a handful of years.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |